Back when I started getting into menswear in 2011-2012, the most recommended wallet was a Saddleback ID card holder. I still have that very same one. Front pocket wallets that were slim had a huge popularity then. No one wanted a large bifold wallet that could potentially give you back pain in the long run!
The first time I was able to feel a Tanner Goods Cardholder wallet was at Unionmade’s flagship in San Francisco. I noticed that the current version was made with a full cover flap instead of an angled flap piece that I had seen online.
I purchased the Tanner Goods Legacy Cardholder in Chestnut Dublin leather sometime in early 2015 for about 85$. It was the first time TG brought back the “angled design” now calling it Legacy Cardholder. To me, the cardholder with the angled flap is the iconic Tanner Goods piece. The Dublin cardholder started with very interesting characteristics such as tiger striping. The dublin leather felt very similar to Chromexcel but seemed to have more variation.
What’s cool about the design is that it’s made from only two pieces of leather. On the rear side there are two wrap around leather pieces from where you can store folded bills. The interior can support up to about 15 cards and will still even stretch to accomodate more (depends on the leather). You can also place cash in the interior with a bill folded in half once in either orientation.
What I love: Simple and iconic design. Quality leather and hardware. Made in the USA.
Ehh: Takes time to get used to a cardholder (looking for credit card within the stack of cards) but all cardholders essentially have this problem. Bills have to be folded in an “undesired” way – either folded twice to fit in the back or folded once and creased on the edge.
